Furuno CI-68 Manuel d'utilisateur télécharger pdf (Page 12)

1. OPERATIONAL OVERVIEW

1-2

1.2 Turning the Power On/Off

1. Press the [POWER] switch at the left hand side of the control unit to turn the power on. A

beep sounds, the equipment turns on, and the lamp above the switch lights. The

equipment conducts the diagnostic test to check for proper operation between the

transceiver unit and the control unit and displays the results. After the diagnostic test is

completed the last-used display appears.

XX: Program Version No.

CI-68

CI-6888

VOL.6651000-XX.XX

MEM. 1 2 3 OK

CI-6810

VOL.6651001-XX.XX

TBL.

MEM. 1 2 3 4 5 6 7 8 OK

ANA.12V;12.03V BV; 110.0V

TRM. +25.02 C

DSW. 00

00 00 00

DSW.

00 00 00

Diagnostic test

Note: The example screens shown in this manual may not match the screens you see

on your display. The screen you see depends on your system configuration and

equipment settings.

2. To turn the power off, press the [POWER] switch again.

Note: The NAV mode measures tides in deep waters where ground tracking is not available.

To use this function effectively, accurate heading data (from a gyrocompass, satellite

compass) is necessary. For further details, see page AP-3.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 71 72

Pas de commentaire

Furuno CI-68 Manuel d'utilisateur Page 12