Furuno 2167DS-BB Manuel d'utilisateur télécharger pdf (Page 40)

2-16

Processor unit, inside view

How to adjust the overvoltage detection circuit:

1. Add or remove the jumper connector P108 as appropriate and change the fuse, referring to the

table on the previous page for details.

2. On the PWR board, set R21 fully clockwise.

3. Connect a variable transformer between ship's mains and the input power terminal board TB-

1 in the processor unit.

4. Adjust the variable transformer output (i.e., input voltage to the processor unit) as follows:

For 100 VAC set: 144 VAC

For 220 VAC set: 288 VAC

5. Turn on the radar and rotate R21 counterclockwise gradually until the overvoltage detection cir-

cuit activates (i.e., power supply cuts off).

6. Lower the output voltage of the variable transformer and confirm that the radar automatically

turns on with a voltage lower than 142 VAC or 284 VAC.

7. Gradually increase the output voltage of the variable transformer and confirm that the over-

voltage detection circuit activates at 144 V or 288 VAC of the variable transformer output.

8. Assemble and connect the processor unit.

J104

J103

J106

J105

J101

PWR board

(P)HV

AC FIL

P108/J108

R21

(OVER)

8 7 6 5 4 3 2 1

Jumper connector

(VH8P)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 110 111

Pas de commentaire

Furuno 2167DS-BB Manuel d'utilisateur Page 40