Furuno 2167DS-BB Manuel d'utilisateur télécharger pdf (Page 29)

2-5

13.In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket

onto the HV cable.

14.As shown in the figure below, fold back the armor onto the flat washer and insert it thru the

other flat washer. Cut off the part of the armor that protrudes past the washer.

15.Pass the HV cable through its cable gland and tighten gland nut.

16.Using the terminal opener, connect wiring to TB901, referring to the interconnection diagram.

17.Close the cover.

18.Seal the cable gland for the HV cable with putty.

Fabricating the power cable TYPCY-2.5

1. Use a ratchet or box wrench to open the port-side cover on the antenna unit.

2. Unfasten the gland nut for the power cable and remove gasket, flat washer (3 pcs.) and gland

cap. (The gland cap may be discarded.)

3. Fabricate the power cable as shown below. Unravel the armor. Wrap sheath with vinyl tape to

fix base of vinyl wire.

How to fabricate power cable TYPCY-2.5

(1)

Flat washer

(2) (3)

Cut off armor that

protrudes past washer.

Gasket

HV cable

Gland nut

High voltage is present at the No. 6 pin

of TB901. Miswiring at this pin can

damage the antenna unit.

CAUTION

25 mm

5 mm

FV2-4

Sheath

Armor

Vinyl sheath

Conductor

S = 2.50 mm

φ = 2.01 mm

Armor

Sheath

SECTIONAL VIEW

230 mm

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 110 111

Pas de commentaire

Furuno 2167DS-BB Manuel d'utilisateur Page 29