Furuno FM-8700 Manuel d'utilisateur télécharger pdf (Page 10)

The mounting procedure for flush mount (option)

Requires flush mount kit OP05-73 (optional supply). Prepare a cut-

out in the mounting location whose dimensions are as shown in the

Figure 3.

Flush Mount Kit (OP05-73)

.oNemaNepyTyt'Q.oNedoC

1etalptnuomhsulF1321-370-501182-932-001

2wercsgnippaT403SUS02x54048-208-000

3wercs.xeH61x8M2570-288-000

Figure 3 Mounting dimensions for flush mount

Duplexer Unit

General mounting consideration

• Locate the unit in a place free of water spray and water splash.

• Keep the unit out of direct sunlight because of heat that can build

up inside the unit.

• Leave a little slack in cables to allow a service technician to move

the radio from its usual location with the cables connected. This

lets him make tuning and other adjustments on a "live" set.

• Do not install the unit where flammable gases are stored.

• Select a well ventilated area.

• Ensure the mounting location is strong enough support the weight

of the unit (2.7 kg) under the condition of continued vibration nor-

mally encountered aboard the vesssel. If necessay, reinforce the

mounting area with a doubling plate or lining block.

• Leave sufficient space at the sides and rear of the unit for mainte-

nance and service purposes and to provide for circulation of cool-

ing air.

Mounting the unit

Mount the unit with four tapping screws supplied.

150

205

261

max 14

106

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

Pas de commentaire

Furuno FM-8700 Manuel d'utilisateur Page 10